The curtain in the bathroom often interferes than helps. The fact is that a lot of time it just hangs at hand. Her place is at the top, under the ceiling in a curled state.
You will need: a pipe from the cornice, a curtain to the bathroom, roulette, drill, an old slender printer (holders from it), plastic cable tray, aluminum strip, screws.
You need to take the pipe from the old cornice and cut it to the desired size. Holders can be attached to it on both sides, they can easily be made from the remains of a jet printer.
Then it is worth disassembled and remove the rod of the spring holder. And then attach the roulette to the cornice tube and push it to the wall.
Cut the curtain to the width you need, glue it carefully to the cornice using tape.
Attach a piece of plastic cable tray to the curtain. It is very important to weight a cable tray with an aluminum strip.
The canvas must be lowered to the stop in order to adjust the tension of the roulette (pull the measured ruler until the curtain begins to rise). Slightly loosen the tension and cut out the extra ruler, and then bend for reliability.
In order to remove the curtain in the bathroom, you just need to just raise the bottom of the curtains – and it will just return to the whim, to its original position.
Such a roll-storm is practical, as well as convenient and is installed very simple.
